




Precision Raceworks
G8x/G2x Stand Alone Auxiliary Fuel System
Pump Selection
G8x/G2x Stand Alone Auxiliary Fuel System
AFS.425
CON5X DROPSHIP
11450 Cherokee Street
A-1
Northglenn CO 80234
United States
Choose options
Pump Selection
Pump Selection
The Precision Raceworks G8x/G2x Stand Alone Auxiliary Fuel System is the highest performing and most stable low pressure fuel system on the market! Forget about how things have been done and embrace the benefits of dedicated fueling for your port injection!
Since direct injection came out for BMW, enthusiasts have been adding port injection. With this came the need to upgrade the low-pressure fuel system to keep up. Historically this was done by increasing the output of the main fuel system. Unfortunately, the main fuel pump is controlled using PWM by a factory programmed controller designed to reduce output when target fuel pressure (typically 5 bar) is exceeded, creating a constant battle when pumps are added or upgraded. This limits upgraded fuel pumps from performing to their full potential.
Additionally, the high pressure pump control system dumps fuel back into the low pressure system at high pressure low volume resulting in oscillations of the low pressure fuel system. Because of this the DI system in the car is required to constantly make corrections to keep target AFR in check.
With this stand-alone low-pressure fuel system dedicated to your port fueling that is a thing of the past! Get rock solid fuel pressures at any pressure, run fuel pressures which are 1:1 scalable to boost pressure, flow more fuel with dedicated lines, run smaller injectors and still get more fuel than you did with large injectors (allowing for higher resolution), put less demand on the car’s DI system to correct for fluctuations in pressure, even your tuner will be grateful as the system makes tuning of port fueling even easier and more accurate, the list of benefits goes on and on!
Features & Benefits
- Billet Aluminum top hat with 3 high flow fuel ports
- Dedicated fuel pump(s) for port injection system
- Optimal pump location resistant to fuel slosh under acceleration
- Fully adjustable 1:1 scaling billet fuel pressure regulator
- 10 micron USA made Microglass fuel filter (Ideal for E85)
- Smooth bore high flow PTFE fuel feed & return lines (AN6)
- All billet connections for both fuel line fittings and top-hat
- Plug and play connectors inside and outside* the top hat
- Configurable pump activation harness (see instructions for more details)
- Increased injector flow (when using 1:1 regulator feature vs static)
- Compatible with all stock or upgraded primary fuel pumps
- Easily expandable and upgrade-able for more fuel
- All components and parts feature 100% Ethanol Compatibility
Models & Configurations
- AFS.425
The AFS.425 dedicated auxiliary fuel system comes with all** necessary components to provide dedicated fuel system for port injection. Featuring a single Walbro 450 (F9000274) fuel pump which flows 425LPH at 3 bar.
- AFS.460
The AFS.460 dedicated auxiliary fuel system comes with all** necessary components to provide dedicated fuel system for port injection. Featuring a single Walbro 535 (F9000295) fuel pump which flows 460LPH at 3 bar.
- AFS.640
The AFS.640 dedicated auxiliary fuel system comes with all** necessary components to provide dedicated fuel system for port injection. Featuring Two Walbro 450’s (F9000274) fuel pumps with a combined flow of 640LPH at 3 bar.
- AFS.745
The AFS.745 dedicated auxiliary fuel system comes with all** necessary components to provide dedicated fuel system for port injection. Featuring One Walbro 450 (F900074) & One Walbro 535 (F9000295) fuel pumps with a combined flow of 745LPH @ 3bar.
- AFS.800
The AFS.800 dedicated auxiliary fuel system comes with all** necessary components to provide dedicated fuel system for port injection. Featuring Two Walbro 535’s (F9000295) fuel pumps with a combined flow of 800LPH at 3 bar.
*At time of install some wiring in the car may need to be cut and spliced to connectors included in this kit
**Male AN8-ORB to Female AN6-ORB adapter may be required for compatibility with some fuel rails (not included in kit)
The items installed or applied to vehicles are intended strictly foroff-road use onlyandtrack vehicles. These modifications may not comply with emissions, safety, or environmental regulations required for public road use underEnvironmental Regulatory Agency (ERA)laws. It is the sole responsibility of the vehicle owner or operator to ensure adherence to all applicable local, state, and federal regulations. Use on public roads may result in legal penalties or vehicle impoundment. Always verify compliance with local authorities before installation.
We get a large number of custom orders and requests everyday, so as a result it is not always possible for us to keep every item in stock at all times in our warehouse. If you require the item urgently please contact our sales team here to check the stock before you make your purchase.
If you're unsure whether a part will fit your vehicle, feel free tocontact us herewith your inquiry. Our helpful sales team will reach out to confirm if it's the right match for you.
We offer a flat-rate shipping fee across thecontinental United States. This excludes Alaska, Hawaii, and U.S. territories. For international orders, additional shipping costs will apply. Please contact us for a quote if you are outside the continental U.S.
Also, feel free to also contact us at ColoradoN5X@Gmail.Com for any other questions.
Not all items are covered by warranty. Items including warranty, will clearly state that there is warranty within the product description. Most of these items will be a standard 1-year warranty against manufacture defects. You, the customer, will be responsible for shipping and handling. We will fix/replace that item with a product that is in working condition if you meet the warranty criteria. Please note that you will be allowed ONLY 1 claim within the year for that product. ColoradoN5X is not responsible for any damage caused during the installation of our products.
PLEASE NOTE
- Orders with both in-stock and backorder or out-of-stock products will be dispatched once all products are available to ship together.
- Contact our sales team if you want your parts fitted to your vehicle at our London workshop.
- Shipping estimates are based on courier delivery times and don't include time to despatch from our warehouse.